Rennsteig

for turned contacts 0.14-1.0; 1.5, 2.5 and 4.0mm˛

can be used u. a. for:

Crimping Tool with Standard ident in plastic case (without locator)

• suitable for crimping turned pin and socket contacts (e.g. HTS, Harting, Ilme...)
• Conductor cross-section area 0,14 - 6,0 mm˛
• Indents ajustable in 0,01 mm increments, digital reading
• Calibration by means of supplied go - no go gauge
• RESET function for recalibration
• Reliable crimping with force lock and synchronous crimp jaw movement
• Multifunctional digital display, with settings shown in mm, inches or MIL selector positions
• Mapping Locator position to Crimp spine position via the enclosed matrix

new Rennsteig article No.: 8753 0401 61

Four-indent crimping tool with standard locator in plastic case

• use for crimping of turned male and female contacts (e.g.. HTS, Harting, Ilme...)
• Wire range 0,14 - 6,0 mm˛
• Crimp dimensions adjustable in 0,01 mm increments
• Calibration by means of enclosed go - no go gauge
• Forced locking system and synchronous drive of indenters for high reliable crimp connections
• Manufacturer: Rennsteig Werkzeuge